Hatco Glo-Ray GR5A, Installation And Operating Manual

English

Form No. GR5ALM-0217

14

OPTIONS AND ACCESSORIES

Non-Adjustable Stands

Aluminum, non-adjustable stands are available as a factory-

installed option for the permanent mounting of GR5A and 

GR5AL Series strip heaters to a countertop. They are available 

in heights of 10″ (254 mm), 12″ (305 mm), 14″ (356 mm), and 

16″ (406 mm).

  1.  Determine the exact mounting location on the countertop 

for the unit. Refer to “Installation Site Requirements” in the 

INSTALLATION section of this manual.

  2.  Prepare the location of each stand mounting flange on the 

countertop.

a. Cut out the mounting flange templates provided on this 

page. Use the templates for accurate mounting hole, 

conduit hole, and LED hole locations.

IMPORTANT NOTE

Make sure the page has not been scaled in size. Measure the 

box on the bottom of this page to check accuracy.

b. Refer to the “Stand Mounting Measurements” table 

and the illustration in this section for unit-specific 

measurements.

c. Verify which stand will have the conduit and LED wire 

leads passing through it and the countertop.

d. Carefully measure, locate, and tape each template onto 

the countertop at its appropriate position.

e. Drill holes through the approriate “Drill Here” locations on 

each template.

NOTE: Do not drill LED wire hole for GR5A series strip heaters.

 3. Feed the conduit and LED wire leads from the unit 

through the appropriate holes, and position the unit on the 

countertop.

  4. Fasten the stands to the countertop using appropriate 

fasteners (not supplied by Hatco). Each mounting flange 

has two mounting hole locations.

  5.  Route the element wire leads and LED wire leads toward 

the installation location for the control box. Refer to the 

INSTALLATION section of this manual for control box/

control installation.

NOTE: Mounting hole size will be determined by fastener size.

This box is 

2″ x 2″ when 

printed 

correctly.

Check page scaling if box  

is not 2″ x 2″ when printed.

LED Drill Here

Ø = 0.25"

(6mm)

Conduit

Drill Here

Hole Cutout Ø =

1-3/32″

(28 mm)

Mounting

Hole

Mounting

Hole

Mounting

Hole

Mounting

Hole

Stand Mounting Flange Templates