OPTIONS AND ACCESSORIES
Form No. GRHWm-0111
13
4-Sided Sign Holder
a 4-sided sign holder is available as an accessory for the
GRHW-1SG model only. Use the following procedure to install
the 4-sided sign holder.
1. Remove the four upper screws from the top four corners of
the unit.
2. align the bottom screw holes on the front and rear long sign
holder brackets with the screw holes on the unit.
3. Secure the two long sign holders to the unit using the
previously removed screws.
Figure 19. Installing the Front and Rear Long Sign Holders
4. Install the side sign holders to the front and rear long sign
holders. To install a side sign holder:
a. Clip the hemmed top edge the side sign holder over the
top edge of the front and rear long sign holder brackets.
at the same time, guide the threaded studs near the
bottom of the side sign holder through the mounting
holes on the front and rear long sign holder brackets.
Figure 20. Installing a Side Sign Holder
b. Secure the side sign holder to the two long sign holders
by attaching the supplied cap nuts to the threaded studs.
Screw
Long
Sign Holder
Side Sign
Holder
Rear Long
Sign Holder
Front Long
Sign Holder
Hemmed
Edge
Hemmed
Edge
Figure 21. Securing the Side Sign Holders
4" (102 mm) Adjustable Legs
4" (102 mm) adjustable legs are available as an accessory for
GRHW-1P and GRHW-1SG models and are standard on
GRHW-2P models.
Overhead Heat Controls
Overhead heat controls are available options for GRHW-1P,
-2P, -1SG, and -1SGS models. an infinite control allows the
operator to manually adjust the upper heat output from full
wattage down to any desired level.
Hardcoated Bin
Hardcoated bins are available as accessories for GRHW-1SG,
GRHW-1SGS, and GRHW-1SGD models. The dimensions of
hardcoated bins are 4″W x 13-1/4″D x 1″H.
Figure 22. Hardcoated Bin accessory
Long Sign
Holder
Brackets
Side
Sign
Holder
Cap
Nut
Threaded
Stud
Summary of Contents for Glo-Ray GRHW-1SGD Series
Page 15: ...NOTES Form No GRHWm 0111 15...