MAINTENANCE
8
Form No. LWm-0512
General
Portable Lamp Warmers are designed for maximum durability
and performance, with minimum maintenance.
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
Do not use ammonia-based cleaners on unit.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
Daily Cleaning
To preserve the finish of the unit, it is recommended that all
surfaces be wiped daily with a non-abrasive, damp cloth.
1. move the ON/OFF switch to the OFF position and allow
the unit to cool completely.
2. Wipe down the entire unit with a clean, non-abrasive,
water-dampened cloth. Stubborn stains can be removed
with a mild, non-abrasive cleanser.
3. Wipe dry the entire unit using a clean, non-abrasive cloth.
NOTICE
WARNING
Replacing a Heat Bulb
Each standard wattage Portable Lamp Warmer holds two
infrared heat bulbs rated at 250 W.
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement Parts
are specified to operate safely in the environments in which
they are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow them
to operate safely in Hatco equipment.
1. To replace a bulb, move the ON/OFF switch in the OFF
position and allow the bulbs to cool completely.
2. Bulbs have a threaded base. Unscrew the heat bulb from
the unit and replace with new bulb.
NOTE: Refer to the
OPTIONS aND aCCESSORIES
section
for replacement heat bulbs available from Hatco.
Replacing a Heat Bulb
WARNING
ON/OFF
Switch
Heat
Bulb