PROGRAMMING THE UNIT
Form No. TFC461RM-0108
7
10.The display shows
(Lower Time Value). Repeatedly
press Up
or Down
arrow key to scroll to desired
setting. Values change by 1 second every time an arrow
key is pressed. Holding down an arrow key will cause the
numbers to change rapidly.
Time can be adjusted from zero to 9 minutes 59 seconds.
11. Press the Enter
key to proceed to the next step.
12.Press the program selection key selected in Step 1 to save
all the settings into memory. The display will show
.
13.Repeat steps 1–12 to program the remaining program
selection keys 1–8.
1. With display showing
, simultaneously press/hold
the
desired
program
selection
key
(1–8)
and
Enter
key for five seconds.
2. After 3 seconds, the upper heat indicator glows and the unit
displays
(Upper Power Value).
3. Repeatedly press the Up
or Down
arrow key to scroll
to desired setting.
4. Press the Enter
key to proceed to the next step.
5. The
display
shows
(Upper
Time
Value).
Repeatedly press Up
or Down
arrow key to scroll to
desired setting. Holding down an arrow key will cause the
numbers to change rapidly.
Time can be adjusted from zero to 9 minutes 59 seconds.
6. Press the Enter
key to proceed to the next step.
7. The lower heat indicator glows and the display reads
(Lower Power Value).
8. Repeatedly press Up
or Down
arrow key to scroll to
desired setting.
9. Press the Enter
key to proceed to the next step.
KEYS 1 – 8 (CYCLE ONCE WHEN PRESSED)
1. Plug unit into an electrical outlet of the correct voltage,
size and plug configuration (see SPECIFICATIONS for
details).
2. Move POWER switch to ON position. The unit will make
an audible beep, automatically go into preheat, and the
display will indicate
..
3. After one minute and ten seconds, the preheat cycle is
complete, the display reads
and is ready to be
programmed.
4. Proceed to keys 1–8 or keys 9 and 10.
ALL UNITS
Summary of Contents for THERMO-FINISHER TFC-461R
Page 19: ...NOTES Form No TFC461RM 0108 17...
