15
Form No. TQ2CEM-1105
MAINTENANCE
ACCESSORIES
GENERAL
The Hatco Toast-Qwik Electric Conveyor Toasters are
designed for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF, unplug the
unit from the power source and allow to cool before
performing any maintenance.
WARNING
If the Warning light on the control panel is lit, appliance is
malfunctioning. Turn OFF the power to the unit and allow
to cool. Once cool, disconnect appliance from power
supply and have unit serviced by a qualified technician.
CLEANING
Exterior
To preserve the bright finish of the unit, it is recommended that
the exterior surfaces be wiped daily with a damp cloth.
Stubborn stains may be removed with a good stainless steel
cleaner or a non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners could
scratch the finish of your Toast-Qwik toaster marring its
appearance and making it susceptible to soil
accumulation.
Toast Crumb Tray & Toast Collector Pan
Remove from unit and wash with soap and water, then rinse.
Toast Feed Ramp
Press in the two wire spokes and remove guide from unit. Wipe
clean with a soft, damp cloth or soak the guide in a mild
solution of 227 milliliters of ammonia and 3.785 liters of water
(1 cup and 1 gallon). Re-install guide by aligning wire spokes
with holes in toaster.
Bottom Heating Reflector
The bottom heating element reflector has slots which allow
bread crumbs to drop through to the crumb tray. Over an
extended period of use bread crumbs may buildup on the
reflector and not drop through onto the tray. To remove buildup,
allow the toaster to cool and wipe the crumbs onto the crumb
tray using a bristle brush.
LUBRICATION
The conveyor gear motor and conveyor system are
permanently lubricated and require no lubrication.
WARNING
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 414-671-6350; International fax 414-671-
3976.
WARNING
This product has no “user” serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco Parts
when service is required.
WARNING
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in
Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use
Hatco Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn.
SECURITY COVER
The security cover flips up to limit access to the control panel
and flips down for access to the control panel.
1. Remove the toast crumb tray.
2. Remove screws. See 15 .
3. Position security cover over control panel.
4. Attach security cover using screws removed in step 2.
5. Install the toast crumb tray.
Summary of Contents for TOAST-QWIK TQ-800 Series
Page 77: ...77 Form No TQ2CEM 1105 NOTES ...
Page 78: ...78 Form No TQ2CEM 1105 NOTES ...
Page 79: ...79 Form No TQ2CEM 1105 NOTES ...
