POWER
Base Temperature Display
Figure 6. Control Panel
Form No. UGMW1M-0307
6
OPERATION
CAUTION
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
WARNING
The unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
CAUTION
Unit is equipped with a factory-set base
thermostat control. Adjustments must only be
performed by authorized personnel.
GENERAL
The main power of the Merchandising Warmer is
controlled by the ON/OFF rocker switch. The switch
must be in the ON position for the unit to function.
Allow 20-30 minutes to reach operating
temperature.
NOTE: Upper heating elements are controlled by an
infinite switch located at the rear base. Adjust the
upper element heat by rotating the control knob to
the desired setting.
CAUTION
Standard and approved manufacturing oils will
smoke up to 30 minutes during initial start-up.
This is a temporary condition. To assure safe
operation, operate unit without food product
until smoke dissipates.
Recessed Base
Temperature Control
On/Off Rocker Switch
Infinite Switch - Upper
Heating Element Control
