8
CHANGING HANDLE DIRECTION
Default settings - System initialization
Install the battery, press the "Reset" button on the back panel for 5 seconds,
then press "000 #" on the keypad. Initialization is complete.
To change the handle
direction on the front
panel, remove the screw
inside the spindle hole.
Remove the handle.
After
adjusting
the
direction, mount in the
screw in order to place
the handle.
To change the handle
direction on the back
panel, remove the screw
inside the spindle hole.
Remove the handle.
After
adjusting
the
direction, mount in the
screw in order to place
the handle.
Summary of Contents for TA-311
