4 Install
9
4
Install
Risk of explosion!
The discharging power pack may generate sparks which ignite
gases, dust or similar substances.
• Never install or use the discharging power pack in areas with
potentially explosive atmospheres.
Electric shock hazard!
An electric shock hazard results from a faulty connection of the
discharging power pack to the power supply.
• The discharging power pack must only be installed by a trained
and qualified electrician.
Damage to equipment!
Continuous overloading of the discharging power pack may result in
failures.
• Never exceed the permissible connected length.
• Never install the discharging power pack on a surface generating
or radiating heat.
• Never install at a location subject to direct solar irradiation.
1. Check the model plate of the discharging power pack against the
ordering data. In the event of damage to the discharging power
pack, contact HAUG GmbH & Co. KG.
2. Before connecting, make
sure that the correct supply
voltage is available for the
discharging power pack.
• The model plate
attached to the housing indicates the voltage.
• If the supply voltage is incorrect, the discharging power pack
may be damaged.
Summary of Contents for EN 8 LC
