Page 4
Item 62253
For technical questions, please call 1-888-866-5797.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY AND PROPERTY DAMAGE:
Do not attempt to install this product if you are not comfortable and
skilled at doing this type of work. This is a custom installed product
that requires precise measurements and drilling that is unique to each
trailer’s design and size. Use an experienced qualified professional
installer to install and inspect the fabrication and final installation.
“A” Frame Tongue Installation Instructions
NOTE:
Fasteners sold separately.
1. Measure the width of the trailer
tongue on which the Steel Box is to
be mounted. Mark the inside of the
box at 1-1/2″ to 2″ from front and
back of the box inner side and about
2/3rd of the Tongue width from the
sides of the box. Punch drill locator
guides with a center punch.
2. Drill a 1/8″ guide hole at one location.
Position the Steel Box on the Tongue
and mark the chassis through the
drilled hole. Remove the box and make
sure that the marked position on the
chassis is in an appropriate location,
keeping in mind that you would be
drilling 1/4″ hole in that position.
3. Repeating the above mentioned
steps, mark the remaining three
spots and verify their proper
location on the chassis.
4. In the bottom of the Steel Box drill
four 17/64″ holes and remove metal
shavings. Attach a 1/4″ rubber grommet
(not supplied), to each hole.
5. Make sure that there are no hidden
electrical wires of conduits below
the marked spots and drill a 1/4″
hole at each location on the chassis.
Clean all metal shavings.
6. Reposition the Box over the tongue
aligning the drilled holes.
