Page 4
For technical questions, please call 1-888-866-5797.
Item 68761
Sa
FE
ty
Op
E
ra
ti
O
n
M
aint
E
nan
CE
SE
t
U
p
Set Up
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product
Note: For additional information regarding the parts listed in the following pages,
refer to
Parts Lists and Diagrams
on page 8.
tool Set Up
Handle assembly
1. Remove the three Screws (D611)
from the Handle Bracket (D151).
2. Set the Handle (D610) on the Handle
Bracket. Make sure the Chain (D612),
Chain Bolt (D614) and Nut (D615) pass
through the large opening in the center
of the Handle Bracket and the hole in the
center of the Handle Bracket Shaft (D153).
3. Slide a Washer (D616) onto each Screw.
Insert the Screws through the base of
the Handle into the Handle Bracket and
tighten securely with a torque wrench
(sold separately) to no more than 43 ft-lb.
4. Raise the Pump Lever (D132) on the
Pump and insert the Chain Bolt into the
slotted open end, keeping the Nut on the
underside of the Pump Lever.
Chain
Chain attachment Detail
Chain
Bolt
pump
Lever
nut
Chain
Screw
Handle
Washer
Handle
Bracket
pump
Chain
Bolt
pump
Lever
nut
Figure a