Page 5
For technical questions, please call 1-888-866-5797.
Item 68761
Sa
FE
ty
Op
E
ra
ti
O
n
M
aint
E
nan
CE
SE
t
U
p
Control Lever
The Control Lever on the Handle has three
operating positions: Lift, Drive and Lower.
a. Lift – Move the Control Lever down to its
lowest position. Pump the Handle frame
up and down to lift the Jack Forks.
b. Drive – Move the Control Lever to the center
position. The Jack Forks do not change position
when in drive. This position is used when the
load is moved from one location to another.
c. Lower – Hold the Control Lever up in its highest
position. This position automatically moves the
Forks to their lowest level. This position is only
in place as long as the Control Lever is held up.
The Lever moves back to the Drive position
when released.
if the Control Lever Does not Function properly
Make adjustments as described in the following chart by loosening the Lock Nut (D134) and
turning the Control Adjustment Screw (D133). After each adjustment, tighten the Lock Nut and
check that all positions of the Control Lever function properly and re-adjust if needed.
Control
position
problem
turn adjustment Screw (D133):
Drive
Forks rise instead of
staying in neutral.
Clockwise until pumping action
does not raise forks.
Drive
Forks lower when Control
Lever is in
drive
position. Counterclockwise until forks do not lower.
Lower
Forks do not lower.
Clockwise until raising the Control Lever
to the
lower
position lowers the Forks.
Lift
Forks do not elevate.
Counterclockwise until the Forks elevate
while pumping in the
lift
position.
Figure C
Components and Controls
Steering
Wheels
Load rollers
Control Lever
Forks
Handle
Handle
Handle
Control Lever
lower
lower
drive
drive
lift
Figure B
Pump
Pump
Lock Nut
Lock Nut
Control
Control
Figure D
