44
24203 3237 0
E 06 10
EN
Engine-powered articulated lifts, 12 - 26 m
C
- Machine layout
C o m m o n l a b e l s
O1
7814 705 b
WARNING
THIS MACHINE MUST NOT BE USED UNTIL IT IS INSPECTED
AND OPERATING PROPERLY.
DO NOT operate this machine unless you have been properly trained as
described in the HAULOTTE Operation and Safety Manual by a qualified person
and authorized to operate this machine. Your training includes reading and
understanding the safety, operating and maintenance instructions in
manufacturer's manuals, knowing your employers work rules and applicable
governmental regulations.
Follow the instructions in the Operating Manual and sections 6, 7 and 8 of
ANSI A92.5-2006 for daily, frequent and annual inspections. These may be obtained
from your authorized HAULOTTE, Inc. equipment dealer or HAULOTTE, Inc.
DO NOT replace items (i.e., batteries, tires, counterweight, etc.) with items of
different weight or specification because this will affect the stability of the
machine.
DO NOT modify or change this machine without written approval from the
manufacturer.
Operate this machine with extreme caution. STOP all operation if a malfunction
occurs.
Test foot switch for proper operation.
RECOMMENDATIONS FOR USE
DAILY INSPECTION
INSTRUCTION BEFORE USE
Test high engine and high drive cut out switches for proper operation.
DO NOT wash the electrical components with a washer pressure.
DO NOT use the machine as a welding earth.
DO NOT weld on the machine without first disconnecting the battery terminals.
Check the level of diesel fuel (for diesel engine platform).
Check that there are no apparent defects (hydraulic leaks, loose bolts,
loose electric connections).
Check that the tilt indicator operates correctly by sounding the buzzer
(when machine is raised).
Remove the rotation locking pin (if there is a turntable).
IMPORTANT when using the AC power line to the work platform, the power plug
must be connected to an electrical installation protected by a circuit breaker.
START-UP
Turn the battery isolater switch to the "ON" position.
Unlock the emergency stop button then press the starter button
(for diesel engine platform).
If the machine does not start, wait 10 seconds then repeat the operation.
The machine
must not be used
while charging the batteries (on electrical machine)
Improper use of this machine could cause death or serious injury.
.
.
.
.
.
..
..
.
..
.
.
.
.
.
.
