130
2420344510 E
11.11
AUS
Telescopic handlers
E
- Attachments
5.10.7 - Precautions to avoid damaging the equipment
5.10.8 - Operation
• Raise or lower the boom to the appropriate height for lifting the load.
• Lift the load smoothly and with the boom fully retracted.
• Travel as specified
Section A - Safety precautions.
5.10.9 - Attachment life expectancy
Section H : Consult this section of the user manual to change the fly jib cable and winch.
Section H : See chapter of the user manual entitled "Operating incidents", to analyse
reasons why the attachment does not work.
Specific instructions concerning use of the equipment can be written and given to the driver by the
company director.
The user must be trained in handling loads at height by an authorised organisation. The user must
therefore strictly adhere to the slinging rules.
For any operation on the winch you must :
• Place the attachment on the ground.
• Stop the carrier vehicle.
• Release the hydraulic pressure.
• Disconnect the hydraulic hoses.
Do not walk under the winch when the lifting arm is in raised position.
Never start up the accessory when other people are nearby.
Grease the following zones every 24 h (
Section H - Lubrication and maintenance) :
• Greasing the roller.
• Greasing the end of course valve.
• The pulley greaser.
Check the attachment fastenings regularly.
If the hook is damaged, stop using the attachment immediately. Change it.
If the winch frame is hit, "stop using the attachment immediately".
The attachment must be inspected by an authorised organisation to validate its capacity.
Contact HAULOTTE Services®.
If the load is exceeded, or the attachment is used abnormally (driving while loaded, etc.) have the
attachment checked by an authorised organisation or contact HAULOTTE Services®.
Never do any work on the mounted attachment without switching off the engine.
Summary of Contents for HTL 3210
