75
2420344510 E
11.11
AUS
Telescopic handlers
E
- Attachments
Attachments
1 - Approved attachments
To determine whether an attachment is approved for use on the machine in use, proceed as follows
before installation of attachment :
• The attachment model/option number indicated on the attachment identification plate must
correspond to the attachment number indicated on a capacity chart located in the operator's cab.
• The model indicated on the capacity chart must correspond to the model of the machine being used.
• The center of gravity of the load on the fork (if applicable) must correspond to the center of gravity of
the load indicated on the capacity chart.
• Hydraulically-powered attachments must only be used on machines equipped with auxiliary
hydraulics.
2 - Unapproved attachments
If any of the above conditions are not met, do not use the attachment. The machine may not be equipped
with the relevant capacity chart or the attachment may not be approved for the machine model being used.
Additional information can be obtained from HAULOTTE Services®.
The user must enlist the services of a competent person to familiarise themselves with the test procedures
for the specific attachments they have for the Telehandler. The user is responsible for carrying out any
required checks of the attachment..
The user must ensure that the accessory can be used in the country in which the machine is be used.
Do not use attachments that have not been approved in writing by Haulotte for the following reasons :
• HAULOTTE® cannot establish the capacity range limits for DIY, home-made, altered or other
unapproved attachments.
• An overextended or overloaded machine may tip over with little or no warning, can result in serious injury
or death to the operator and/or those working nearby.
• HAULOTTE® cannot guarantee the ability of an unapproved attachment to perform its intended function
safely.
Only use HAULOTTE approved attachments. Attachments that have not been approved by HAULOTTE for
use with this machine may cause material and/or bodily damage, or even death.
Summary of Contents for HTL 3210
