96
2420333140 E06.13
EN
Telescopic machines, 28 - 43 m
C
- Maintenance
Control cylinder by cylinder :
• Position a load equal to the rated capacity on the cage (or platform).
• Perform the movement of the concern cylinder to half of its stroke.
• Fix the cylinder with a comparator :
• Attach the body of the comparator on the cylinder rod.
• The needle of the comparator must be in contact with the end of the casing of the cylinder.
• The target is to measure the creep of the cylinder rod.
• If the creep of the cylinder rod is higher than the values indicated in the table below, replace the
cylinder.
3.3.4 - Electric
3.3.4.1 - Replacing damaged cables
• Locate the faulty wire/s and its/their points of connection to ensure continuity of machine operation
after the wire is replaced.
• Note the cable path to facilitate reassembly.
• Respect the order (configuration) of origin during the reassembly.
Type of cylinders
Maximum drift authorised due to an internal leak of the cylinder
Lift cylinder arm or boom (Machine
with working heights > 26 m(85 ft4 in))
After 10 mn, creep < 0,2 mm
After 60 mn, creep < 1 mm
Outriggers cylinder, Oscillating axle
locking, Lift cylinder arm or boom
(Machine with range-limiting system)
After 10 mn, creep < 0,5 mm
After 60 mn, creep < 2,5 mm
Lift cylinder arm or boom,
Telescoping, Compensation, ...
After 10 mn, creep < 1 mm
After 60 mn, creep < 6 mm
Steering cylinder
After 10 mn, creep < 1,5 mm
After 60 mn, creep < 9 mm
Summary of Contents for H28TJ+
