64
4000328850
E 12 14
USA / GB
HA32PX - HA100JRT - HA41PX-NT - HA130JRT-NT
C
- Pre-operation inspection
4.3.2 - Buzzers test
F r o m t h e g r o u n d c o n t r o l b o x
4.4 - A
UTOMATIC
ENGINE
CUT
-
OUT
The engine automatically cuts out in the following conditions :
• The alternator is not functioning.
• Engine temperature is too high.
• Oil pressure is too low.
• E-Stop(s) are pushed in.
• The machine is switched off.
• E-stop(s) pushed in.
4.5 - O
VERLOAD
SENSING
SYSTEM
(
IF
FITTED
)
If the platform load exceeds the maximum allowed load, no movement is possible from the 2
control boxes.
At ground and platform control boxes a buzzer sounds and an indicator light warns the
operator
To return the machine to normal operation remove weight from the platform until the load is
below the maximum allowed load.
Daily check that the LED's illuminate when the machine is switched on :
• Verify that the Overload system is active : Refer to Indicators ( 6 ) at ground panel and ( 30 )
at platform panel.
• Verify that the buzzers are functioning : Refer to Buzzers test
A periodic inspection of these devices must be performed according to the recommendation
in Maintenance Schedule.
4.6 - O
SCILLATING
AXLES
(I
F
EQUIPPED
)
To improve the driving capability on rough terrain, the front axle is equipped with an oscillating
mechanism. When the extending structure is retracted and is in the stowed position,
oscillating mechanism is unlocked to adapt itself to the features of ground operation. When
the extending structure is out of the stowed position, a safety device locks the oscillating
mechanism to reduce overturning hazard.
A visual inspection must be performed each day to ensure the absence of leaks from the
oscillating cylinder and associated plumbing connections including the hydraulic hoses.
A periodic inspection of this device must be conducted according to the recommendation in
the maintenance schedule.
Step
Action
1
Pull both E-Stop buttons ( 15 ) at ground panel and ( 46 ) at platform panel.
2
Set the ON/OFF key switch ( 18 ) to ON position.
3
Buzzers at ground and platform will beep.
Summary of Contents for HA100JRT
Page 2: ...2 4000328850 E 12 14 USA GB HA32PX HA100JRT HA41PX NT HA130JRT NT...
Page 8: ...8 4000328850 E 12 14 USA GB HA32PX HA100JRT HA41PX NT HA130JRT NT A Foreword Notes...
Page 22: ...22 4000328850 E 12 14 USA GB HA32PX HA100JRT HA41PX NT HA130JRT NT A Foreword Notes...
Page 118: ...118 4000328850 E 12 14 USA GB F Maintenance HA32PX HA100JRT HA41PX NT HA130JRT NT Notes...
