A
B
C
D
E
F
G
H
I
65
4000827180
E 09.18
USA / GB
D
- Operation instructions
HA12CJ - HA32CJ - -
1.4 - O
PERATION
FROM
THE
PLATFORM
CONTROL
BOX
• The platform control box is energized only when :
• The E-stop buttons on both ground and platform control boxes are not pressed in.
• Machine switched on at ground control box.
• Platform control box selected from ground control box.
• Overriding system not activated.
• A faulty joystick is not taken into account to control a movement. If this fault disappears, the
movement is authorised again.
• An E-Stop button is present at each control box. When pushed in, it stops all functions
movements.
N.B.-:-DO NOT
TURN
OFF
THE
POWER
SUPPLY
OF
THE
MACHINE
USING
THE
E-
STOP
BUTTON
(U
SE
ONLY
IN
CASE
OF
EMERGENCY
). T
URN
OFF
THE
POWER
SUPPLY
OF
THE
MACHINE
USING
THE
C
ONTROL
BOX
ACTIVATION
KEY
SWITCH
( 72 )
TO
POSITION
.
• An Enable foot pedal and / or trigger in the basket is present and should be activated to
authorize one or more function movements. If the enable switch is kept active for more than
8 seconds without selecting a function movement, then movement is disallowed. Before
activating other movement controls, the foot pedal ( C42 ) and/or the Enable switch system
must be released in order to reset.
• The release of enable foot pedal and/or trigger while performing a movement stops all the
movements. The stop of movements is progressive. If the enable foot pedal and / or trigger
is pressed again quickly within (0,5 s) the movement restarts. If the enable foot pedal and
/ or trigger is not pressed again quickly enough within ( + 0,5 s ) the movement will not
restart. It could restart only when the selected function switch/joystick is released to neutral
position.
• All switches and joystick operating a movement, return automatically to neutral when
released.
• At power up, all switches and joysticks must be in their neutral position.
• The status of the switches is tested automatically when the machine is switched on, and
checked at every starting.
• A buzzer beeps in the following conditions :
• When power is switched on.
• Overload (if fitted).
• Slope if boom and/or arm is in stowed position.
• Indicators - All the indicators are tested
• When the machine is switched on.
Summary of Contents for HA12CJ
Page 2: ...2 4000827180 E 09 18 USA GB HA12CJ HA32CJ HA12CJ HA32CJ ...
Page 84: ...84 4000827180 E 09 18 USA GB D Operation instructions HA12CJ HA32CJ HA12CJ HA32CJ Notes ...
Page 94: ...94 4000827180 E 09 18 USA GB E General Specifications HA12CJ HA32CJ HA12CJ HA32CJ Notes ...
Page 106: ...106 4000827180 E 09 18 USA GB G Other information HA12CJ HA32CJ HA12CJ HA32CJ Notes ...
