14
EN
REMOVING AND INSTALLING THE FILTERS
fig. 2
fig. 1
1.
Make sure the device is not connected to the power supply.
2.
Rotate the device by 180 degrees, so that the cover (5) faces upwards. Place the device on
a soft cloth so that it does not scratch the surface of the tabletop.
3.
Gently move the slide (6) locking the filter cover (fig.1).
4.
Take out the integrated filter (7) from the housing (8). Be careful not to tip the device over
(fig.2).
5.
Install a new filter in the housing (8). Remove the protective film from the new filter, if used.
6.
Put on the cover (5) and lock it with the slider (6).
7.
Rotate the device back to its normal position (control panel facing up).
8.
If the purifier’s status light (4l) indicated that it is necessary to replace the filter, press the “ON/
OFF” button (4a) and keep it pressed for 5 seconds. The filter’s status light will be reset and
deactivated.
USING THE APPLIANCE
1.
Place the device on a dry, flat and stable surface. Make sure there is enough free space around
the device to ensure unobstructed air circulation. The device may only work in a vertical posi-
tion, its control panel facing up.
2.
Connect the power cord to the mains.
3.
Activate the purifier by pressing the (4g) button – a short beep indicates activation – the
device starts.
4.
Adjust the air purification rate with the (4e) button. There is a choice of four air injection
speeds, indicated successively by bars on the (4c) indicator. Decreasing/increasing the injec-
tion speed can physically take a moment to adjust. The selection of the automatic cleaning
mode “AUTO” is indicated by the (4f) status light. In “AUTO” mode, the injection speed de-
pends, among other things, on the current air quality in the surroundings of the purifier and
can change over time.
5.
During operation of the purifier, the air quality in the room is continuously monitored which
you can read on the air quality indicator (4a). The indicator displays the digital value of sus-
pended particulates with a particle size of 2.5 micrometres or less (PM2.5 – particulate matter
2.5) expressed in micrograms per cubic meter (μg/m³) Additionally, the air quality is indicated
by corresponding colours on the (4j) indicator according to the table below:
HL-OP-11_instrukcja_v01.indd 14
HL-OP-11_instrukcja_v01.indd 14
13.09.2021 12:33:19
13.09.2021 12:33:19
