22
ENGLISH
!
IMPORTANT SAFETY RULES
3.
PRESSURE SWITCH:
The air pressure switch is factory pre-set for optimum
performance. Do not bypass or remove this switch. Serious damage to
equipment or personal injury could result from too high an air pressure.
4.
MOTOR AND COMPRESSOR PUMP:
Air compressors get hot during
operation. Do not touch the motor, discharge tubing, or compressor while it
is running. The compressor turns itself on automatically while the power is
connected.
5.
AIR TANk:
Over-pressurizing the air receiver, piping or tank could cause
it to explode or burst. To protect from over-pressurizing, the compressor is
equipped with a factory preset safety valve. Do not remove, make adjustments
to or substitutions for this valve. Perform a test of the valve from time to time:
pull the ring on the valve to make sure that it operates freely. If the valve does
not operate freely, replace it before further use. Never weld to, drill into, or
change the air receivers in any way.
6.
TAMPERING:
If any of the components above are found to have been
changed or tampered with, the warranty will be made void. When servicing, we
recommend using only identical replacement parts and any replacement parts
used must have the same specification as the original equipment.
WARNING:
The warnings, cautions, and instructions detailed in this manual
cannot cover all possible conditions and situations that occur. It must be
understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS that cannot be built into this product, but MUST BE SUPPLIED BY
THE OPERATOR.
SPECIFICATIONS
z
Motor: 120 volts, 60 Hz, 15 amps
z
3 peak HP
z
3400 RPM single stage direct drive
z
Thermal overload protection to ensure safety and reliability
z
Splash-lubricated pump for long life
z
Cast iron sleeve for durability
z
Aluminum head and finned copper outlet tube for efficient heat dissipation
z
Easy to read oil level sight gauge
z
Uses SAE-20 or 30 (API CG/CD heavy duty) non-detergent compressor oil
z
ASME-approved safety valve
z
Powder-coated paint finish
z
Vertical air reservoir tank saves shop space
z
28 gallon (106 L) air capacity
z
Twin quick-change couplers
z
Air line regulator and dual pressure gauges
z
8” (20 cm) diameter puncture-proof solid rubber tires on steel hubs and chro-
med handle for ease of transport on rough surfaces
z
Air production capacity: 6.6 CFM @ 40 PSI / 5.3 CFM @ 90 PSI (0.187 m
3
@
275.8 kPa / 0.150 m
3
@ 620.5 kPa); the highest available from a 15 amp 120
volt household circuit
z
Maximum pressure: 150 PSI (1034.2 kPa)
z
50% duty cycle
z
Net weight: 154.3 lb. (70 kg)
z
Packed weight: 161 lb. (73 kg)
