Haussmann Xpert 59595043, Operator'S Manual

24

OPERATION

Mechanical Gear Selection

Actuate the gear selector only when the tool is at a standstill.

Two speed ranges can be preselected with the gear selector.

Gear 1:

Low speed range; for screw driving or working with large drilling diameter.

Gear 2:

High speed range; for working with small drilling diameter.
If the gear selector cannot be fully engaged, lightly rotate the driver spindle with 
the drill bit by twisting the drill chuck.

Verify the position of the torque selection ring

1) When using the tool as a driver, align one of the numbers “1,3,5…19” on the 

    torque selection ring, or align the dot with the       triangle located on the tool body. 

2) When using the tool as a regular drill, align the       indicator on the torque selection 

    ring with the triangle located on the tool body.  

3) When using the tool as an impact drill, align the indicator on the torque selection 

    ring with the triangle located on the tool body.

Adjusting the Speed

The speed of the switched on power tool can be variably adjusted, depending on 
how far the On/Off switch  is pressed.
Light pressure on the On/Off switch results in a low rotational speed. Further 
pressure on the switch results in an increase in speed.

Fully automatic spindle locking (Auto-lock)

When the On/Off switch is not pressed, the drill spindle and thus the tool holder 
are locked.
This enables screws to be screwed in, even when the battery is empty and allows 
for the tool to be used as a screwdriver.

Run-on Brake

When the On/Off switch is released, the chuck brakes to a stop, thus preventing 
the run-on of the tool.
When driving in screw, wait until the screw is screwed in flush with the material 
and then release the On/Off switch. By doing so, the head of the screw does not 
penetrate into the material.

Operating Instructions

Apply the power tool to the screw only when it is switched off. Rotating tool 
inserts can slip off.

Soft Grip

The gripping surface (soft grip) reduces the danger of slipping and thereby 
improves the grip on the tool and the handling.
At the same time, the rubber coating achieves a vibration-reducing effect.

Tips

After longer periods of working at low speed, allow the tool to cool down by 
running it for approx. 3 minutes at maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS drill bits (HSS=high-speed 
steel). The appropriate quality is guaranteed by our accessories program.
Before screwing larger, longer screws into hard materials, it is advisable to predrill 
a pilot hole with the core diameter of the thread to approx. 2/3 of the screw length.

ENGLISH