DMT109
ASSEMBLY
20
ENGLISH
MOUNTING/REPLACING THE APPLICATION TOOL/ACCESSORY
Mount the application tool/accessory (e.g. plunge cut saw blade) in such a way on the
tool holder that the openings of the tool engage into the cams of the tool holder. For a
safe and fatigue-free working position it is possible to position the application tools/
accessories in any snap-in positions on the tool holder. Position the tool in such a way
that the depressed centre points downwards (marking on the tool is readable from
above, see figure on the graphics page).
Use the screw to fasten the application tool/accessory.
Tightly fasten the screw with the allen key. Check the tight seating of the application
tool/accessory. Incorrect or not securely fastened application tools/accessories can
come loose during operation and pose a hazard. For removing the application
tool/accessory loosen the screw with the allen key and remove the tool.
MOUNTING/REPLACING A SANDING SHEET ON THE SANDING PLATE
The sanding plate is fitted with Velcro backing for quick and easy fastening of sanding
sheets with Velcro adhesion.
Before attaching the sanding sheet, free the Velcro backing of the sanding plate from
any debris by tapping against it in order to enable optimum adhesion. Position the
sanding sheet flush alongside one edge of the sanding plate, then lay the sanding
sheet onto the sanding plate and press it against it with a light turning motion in
clockwise direction.
To ensure optimum dust extraction, pay attention that the punched holes in the
sanding sheet match with the holes in the sanding plate.
To remove the sanding sheet, grasp it at one of the tips and pull it off from the
sanding plate.
You can use all sanding sheets, fleece pads/polishing cloth pads available at your
local hardware store.
Sanding accessories, such as fleece pads/polishing cloth pads, are attached to the
sanding plate in the same manner.
SELECTING THE SANDING SHEET
Depending on the material to be worked and the required rate of material removal,
different sanding sheets are available:
Particle size
Material
Application
Coarse
40
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
Coarse grinding/sanding (initial
grinding/sanding)
Remove old coatings, etc.
Medium
80, 100, 120
Fine
180 to 400
Fine grinding/sanding
Removal of slight unevenness,
paint spots, etc.
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
painting
Polishing
