A
OPERATING INSTRUCTIONS
19
– 5 hours of charging before use.
Your battery pack will not be fully charged
until you have performed several charge and
discharge operations by charging & working
with your trimmer. After this your battery pack
performance will improve.
The charger and battery pack are specifically
designed to work together so do not attempt
to use any other devices. Never insert or allow
metallic objects into your charger or battery
pack connections because an electrical failure
and hazard will occur.
Fig A
Power indicator(red)
2. How to charge your battery pack
(see Fig A)
Connect the charger base to the battery
charger and then connect the charger to the
power supply. The 3-hour charger is designed
to use standard household 120V 60Hz power -
ensure the supply voltage matches the charger
voltage.
Fully insert the battery pack into the charger
base to make the connection. The battery pack
will only fit into the charger in one direction.
The red light will illuminate to show charging
has started. A discharged battery at normal
ambient temperature will take approximately
3 hours to reach full charge. Do not charge
the battery when it or the air temperature is
below 2
o
C (36
o
F) or above 35
o
C (95
o
F). Ideal
charging temperature is between 18
o
C to
29
o
C (65
o
F to 84
o
F).If the battery pack has
been heavily used, allow time to cool before
charging.
While charging the red LED light will illuminate.
The battery will normally be charged in 3-
hours and should then be removed from the
charger. The red LED light does NOT go out
until the battery pack is removed from the
charger base. While charging, the charger
may hum and become warm to the touch. This
is a normal condition and does not indicate a
problem.
After long usage the battery will become hot,
let the hot battery cool down for 1 hour before
recharging.
3. To remove or install a battery pack
Locate the release buttons on either side of
the battery pack and depress both sides to
release battery pack from the trimmer. Pull the
battery pack from your trimmer. After charging
insert the battery pack into the trimmer’s
battery port. A simple push and slight pressure
will be sufficient.
Fig B
1. Fitting the Guide Wheel (for edging)
Attach the guide wheel onto the underside
of the guard as shown in Fig. B using the 2
screws provided.
Summary of Contents for 325602
Page 27: ...27 ...
