Haussmann 59595050, Manual

SAFETY INSTRUCTIONS

1.  Work area safety

      a) Keep work area clean and well lit. 

Cluttered or dark areas invite accidents.

      b) Do not operate power tools in explosive atmospheres, such as in the 

          presence of flammable liquids, gases or dust. 

Power tools create sparks 

which may ignite the dust or fumes.

      c) Keep children and bystanders away while operating a power tool. 

Distractions can cause you to lose control.

2.  Electrical safety

      a) Double insulated tools are equipped with a polarized plug (one blade is 

          wider than the other.) This plug will fit in a polarized outlet only one way. 

          If the plug does not fit fully in the outlet, reverse the plug. If it still does 

          not fit, contact a qualified electrician to install a polarized outlet. Do not 

          change the plug in any way. 

Double insulation eliminates the need for the 

three-wired grounded power cord and grounded power supply system.

      b) Do not expose power tools to rain or wet conditions. 

Water entering a 

power tool will increase the risk of electric shock.

      c) Handle the cord carefully. Never use the cord for carrying, pulling or 

          unplugging the power tool. Keep cord away from heat, oil, sharp edges 

          and moving parts. 

Damaged or entangled cords increase the risk of electric 

shock.

      d) If operating a power tool in a damp location is unavoidable, use a 

          Ground Fault Circuit Interuptor (GFCI) protected supply. 

Use of a GFCI 

device reduces the risk of electric shock.

      e) When operating a power tool outside, use an outdoor extension cord       

          marked “W-A”or “W”. 

These cords are rated for outdoor use and reduce the 

risk of electric shock.

      f)  Do not use the equipment close to flammable objects.

3.  Personal safety

      a) Stay alert, watch what you are doing and use common sense when 

          operating a power tool. Do not use a power tool while you are tired or 

          under the influence of drugs, alcohol or medication. 

A moment of 

inattention while operating power tools may result in serious personal injury.

      b) Use personal protective equipment. Always wear eye protection.       

Protective equipment such as dust mask, non-skid safety shoes, hard hat, or 

hearing protection used for appropriate conditions will reduce personal injuries.

      c) Prevent unintentional starting. Ensure the switch is in the off-position 

          before connecting to power source, picking up or carrying the tool. 

Carrying power tools with your finger on the switch or energizing power tools 

that have the switch on invites accidents.

      d) Remove any adjusting key or wrench before turning the power tool on.       

A wrench or a key left attached to a rotating part of the power tool may result in 

personal injury.

!

WARNING!  

Read all safety warnings and all instructions. 

Failure to follow the warnings 

and instructions may result in electric shock, fire and/or serious injury.

14

ENGLISH