PNT210-B
18
ENGLISH
Fig.1
B
A
E
F
D
C
G
SPECIFICATIONS
FUNCTIONAL DESCRIPTION
The HAUSSMANN framing nailer is designed to install framing nails of 0.113” to 0.131”
(2.87-3.33 mm) diameter, 2" to 3-1/2" (50-90 mm) long with a fastener collation angle
of 21 degrees including clip-head nails like Bostitch, Campbell Hausfeld and Fasco
nails.
Operating pressure (min. to max.): 70-110 PSI
Air consumption: 4-5 CFM @ 90 PSI
Magazine Capacity: 60 nails
Air inlet: 1/4” (6 mm)NPT
Padded hand grip
Figure 1 names the major components of the HAUSSMANN 21° Framing
Nailer.
A. Deflector
B. Body
C. Non-marring rubber tip
D. Pusher
E. Magazine
F. Air plug
G. Trigger
Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 180 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air resource:
a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
Never connect
tool
to an air source that may exceed 180 PSI. Over pressurizing the
tool may result in bursting, abnormal operation, breakage of the tool or serious
injury to persons. Use only clean, dry, regulated compressed air at the rated
pressure or within the rated pressure range as marked on the tool. Always verify
prior to using the tool that the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
IMPORTANT SAFETY INSTRUCTIONS
