– 13 –
ASSEMBLING STAND (Fig. A, B)
1. Unpack all parts and group by type and size. Refer to
parts list for quantities.
2. Attach four hooks (1) to the top corner of the four
legs (2) as shown. The hooks (1) are used to hold
the dust bag.
NOTE :
Make sure the hook (1) is securely fastened
to the corner of the leg (2).
3. Attach one long upper support (3) to top of leg (2)
using one square neck bolt (4) and nut (5).
(Fig. B)
NOTE :
●
Align detents (6) in stand leg with support
brackets to ensure proper fit.
●
Do not tighten bolts until stand is properly
aligned.
●
Position all supports to the INSIDE of the leg
assembles.
4. Attach other end of long upper support to top of
another leg using one square neck bolt and nut.
5. Attach one long bottom support (7) to centre of each
leg using square neck bolt and nut. This completes
the front frame section.
6. Assemble rear frame section in exactly the same way.
7. Join front and rear frame assemblies using two short
upper supports (8) and two short bottom supports
(9), square neck bolts and nuts.
8. Insert large hex head bolt (10) into leg spacer (11)
and insert into bottom of leg. Fasten with washer (12)
and nut (13). Repeat for each leg.
9. Attach the hooks (14) to the frame using screws (15)
and nuts (16) as desired. The hooks are used to hold
the fence.
10. Place stand on level surface and adjust so all legs
are contacting the floor and are at similar angles to
the floor. Tighten all bolts.
NOTE:
Stand should not rock after all bolts are
tightened
.
ASSEMBLY AND ADJUSTMENTS
Fig. A
1
2
1
Front
14
10
9
11
8
2
3
7
6
5
4
12
13
15
16
Fig. B
INSTALLING THE DUST BAG (FIG. C)
●
Do not use this saw to cut and/or sand metals.
The hot chips or sparks may ignite sawdust or
the bag material.
●
To prevent hazard, clean and remove sawdust
from under the saw frequently.
1. The hooks (2) located inside of the four legs are
used to hold the dust bag (1).
2. Attach the dust bag (1) to the four hooks with the
four brass gromments on the dust bag.
1
1
2
Front
WARNING
!
Fig. C