– 14 –
ASSEMBLING TABLE SAW TO STAND (FIG. D)
1. Place the saw (1) on the stand (2).
2. Line up four mounting grooves (3) of the saw base
and the four mounting holes on the top plate of the
stand.
3. Fasten table saw to the stand using four hex head
bolts (4), washers (5) and locknuts(6).
NOTE :
Place washer on each bolt before inserting
into saw base and through the mounting grooves.
Locknuts must be flush against the bracket.
4. Tighten all four locknuts (6).
NOTE :
Do not overtighten the locknuts mounting
the base to stand.
NOTE :
Get the assistance of someone to lift and
move the saw.
SAW MOUNTED TO WORK SURFACE (Fig. E)
1. If the leg set will not be used, the saw must be
properly secured to a sturdy workbench using the
four mounting holes at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole large enough to facilitate
sawdust fall-through and removal.
3. Square the saw on the mounting surface and mark
the location of the four 3/8 in. mounting holes (1).
4. Drill a 3/8 in. hole into the mounting surface.
5. Mark an 11 in. square (2) centered between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
Do not operate this tool on the floor. This is very
dangerous and may cause serious injury.
Failure to provide the sawdust fall-through hole will
cause sawdust to build up in the motor area, which may
result in fire or cause motor damage.
INSTALLING THE BLADE ELEVATION HANDWHEEL
(Fig. F)
NOTE :
UP-DOWN is printed on this handwheel.
1. Attach the blade elevation handwheel (1) to the
elevation rod (2) at the front of the saw. Make sure
the slots (3) in the hub of the handwheel (1) engage
with the pins (4).
2. Attach and tighten the dome nut (5) using a 13 mm
wrench.
INSTALLING THE BLADE TILTING HANDWHEEL
(Fig. G)
1. Attach the blade tilting handwheel (1) to the blade
tilting rod on the right side of the saw in the same
manner as you attached the elevation handwheel.
2. Attach and tighten the dome nut (2).
SQUARE
CUTOUT
2
1
Fig. G
WARNING
!
Fig. F
2
1
Fig. E
1
1
3
4
5
2
rear view
front view
Fig. D
1
2
3
4
5
6
