12
EMM104
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS FOR ELECTRIC MIXER
11. Avoid accidental starting.Be sure switch is off before plugging in.
Carrying
tools with your finger on the switch or plugging in tools with the switch on invites accidents.
12. Remove adjusting keys before turning the tool on.
A wrench or a key that is left
attached to a rotating part of the tool may result in personal injury.
13. Do not overreach.Keep proper footing and balance at all times.
Proper footing
and balance enables better control of the tool in unexpected situations.
14. Use safety equipment. Always wear eye protection.
Dust mask, non-skid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions.
TOOL USE AND CARE
15. Do not force tool.Use the correct tool for your application.
The correct tool will
do the job better and safer at the rate for which it is designed.
16. Do not use tool if switch does not turn it on or off.
Any tool that cannot be
controlled with the switch is dangerous and must be repaired.
17. Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing the tool.
Such preventive safety measures
reduce the risk of starting the tool accidentally.
18. Store idle tools out of reach of children and other untrained persons.
Tools
are dangerous in the hands of untrained users.
19. Maintain tools with care. Keep cutting tools sharp and clean.
Properly
maintained tools with sharp cutting edges are less likely to bind and are easier to
control. Do not use a damaged tool.Tag damaged tools“Do not use” until repaired.
20. Check for misalignment or binding of moving parts, breakage of parts,and
any other condition that may affect the tool’s operation. If damaged,have the
tool serviced before using.
Many accidents are caused by poorly maintained tools.
21. Use only accessories that are recommended by the manufacturer for your
model.
Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
22. Tool service must be performed only by qualified repair personnel.
Service or
maintenance performed by unqualified personnel could result in a risk of injury.
23. When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual.
Use of unauthorized
parts or failure to follow Maintenance instructions may create a risk of electric
shock or injury.
Ensure that the current voltage specified on the rating plate corresponds with the
supply voltage
Do not operate the appliance in an environment with a potentially explosive atmosphere.
Do not mix solvent or substances containing solvents which have a flash point
below 21
o
C.
Do not pass cables around any parts of the body.
The appliance must always be started up and slowed down, in the mixing
container, ensure that the mixing container is firmly fixed in position for these
operations.
Do not reach your hands or any objects into the mixing container when mixing is in progress.
Wear ear protection if the work-place noise level exceeds 85dB(A).
It is advisable to wear gloves and protective glasses during mixing operations, it is
however, compulsory to wear close-fitting clothing.
