1/4”-20 x 3/8”
Pan Head Screws
This loop must be large enough
to allow full range of expected
rotation and extension without
stressing connections.
Collect cables to secure
to the mounting system
(Note: mounting system not included)
6
7
Installation and Cable Management
Installation and Cable Management
(continued)
1)
Remove the Mounting Bracket from the packaging. Install the
Mounting Bracket to the Motion Device using (4) 1/4“-20 x 5/8” long
button head screws (Hardware Kit Item 3).
Torque screws to 80 in-lbs (9.0Nm) ± 10%.
NOTE: Numerous hole patterns present in Mounting Bracket will accomodate Havis Motion
Devices as well as most competitors’
NOTE:
We recommend applying a drop of medium strength (blue)
thread locking adhesive to the threads of all fasteners.
2)
Install all cables that are necessary for computing needs. Use Zip Ties
(Hardware Kit Item 1) to strain relieve cables to the Strain Relief Points,
routing all cables together downward on either or both sides.
3)
Ensuring the bundled cables exit through the opening(s) in the Mounting
Bracket, place the Docking Station onto the Mounting Bracket and secure with
(4) 1/4”-20 x 3/8” long pan head screws (Hardware Kit Item 4).
Torque screws to 80 in-lbs (9.0 Nm) ± 10%.
4)
Secure cable bundle to the Mounting Bracket with a supplied Zip Tie.
5)
Create a service loop with cable bundle to ensure that no tension is on the
connectors and to enable intended motion.
6)
Tie off cables onto a stationary part of the mounting system.
(Mounting system not included with Docking Station)
Use as many Zip Ties as
necessary to secure cables.
1/4”-20 x 5/8”
Button Head Screws
Mounting Bracket
Typical Motion Device Example
(not included)