KK-K9-C22-K_INST_6-12.docx rev 2-14
Attach bracket to window frame with
#10 x 3/4 Phillips pan head sheet
metal screws.
Hold in place and mark location for
frame mounting screws.
Unplug O.E.M. housing
harness.
Remove one (1) floor nut on
driver side and passenger side.
Remove rear seat.
Some hardware to be reused.
View of rear seat before removal.
Remove (2) passenger side
floor bolts and harness clip.
Temporarily remove lower sill
trim.
(T-20 Torx)
Center and attach the window
guard assembly to the door panel
with #10 x 1/2” Phillips pan head
sheet metal screws.
With upper bracket still attached to
guard, position so bracket fits evenly
at top.
Drill mounting holes with 5/32”
drill bit.
Window Guard and Door panel
installation complete.
