KK-K9-C22-K_INST_6-12.docx rev 2-14
Temporarily remove lower “B”
pillar trim.
Temporarily remove upper “B”
pillar trim.
(T-20 Torx)
Pull rubber floor mat down to
exposed location of a 7/16” threaded
nutsert at bottom of “B” pillar.
Use Awl (or other pointed tool) to
locate center of nutsert.
Mark location.
Use 2” long x 1.25” OD Aluminum
spacer as a template to outline hole to
be cut in rubber mat. Cut rubber mat
so spacer fits in against steal body
frame.
Place spacer into location.
One each side.
Attach driver side lower mount
bracket to body with 7/16” x 3”
Hex head bolt and flat washer
Bolt goes trough spacer.
Tighten bolt.
Attach passenger side lower mount
bracket to body with 7/16” x 3”
Hex head bolt and flat washer
Bolt goes trough spacer.
Tighten bolt.
