KK-K9-F18-K_INST_2-13.docx
Remove / unsnap entire door
panel from door.
(Trim removal tool)
Disconnect latch cable from door
handle.
Remove door speaker.
(7mm socket)
Remove rear passenger door panels
first. Behind the door open paddle
handle, remove plastic cover and bolt.
(10mm socket)
Underneath door handle, remove
plastic cover and bolt.
(10mm socket)
Note: A small 90° scribe helps to
pick plastic covers off.
Remove screws at bottom of door
panel. (7mm socket)
Remove window switch from door
panel and reattach it to original
plug. Tape the switch to the vapor
barrier to protect it from moisture.
Carefully remove the door lock
rod from O.E.M. lock assembly.
NOTE: It is very important
that lock rod does not prevent
the electric lock from working.
Removing the rod is
recommended
Example mounting of lock latch release
solenoid for optional Hot-N-Pop
#
K9-A-201
kit.
1.
Drill inner door skin and bolt on
solenoid.
2.
OEM latch cable attaches
directly to solenoid.
3.
You will need to
keep tension on the latch cable using
cable clamps.
4.
Turn latch override
switch to enable lock.
