KK-K9-F18-K_INST_2-13.docx
Shift floor rearward and all floor
tighten hardware.
(7/16 socket)
Note:
Run wiring for Dome light,
rear fan and other equipment prior
to installing floor.
Prior to front bulkhead installation,
remove OEM “B” pillar grab
handles. Attach upper front
bulkhead
flat
“L” bracket to “B”
pillar with OEM grab handle screw.
(“L” flange faces out as shown)
(7 mm socket)
Remove rear seat bracket nuts only.
(21 mm socket) Save Hardware.
DO NOT remove OEM support
brace hardware.
Remove rear seat side bolts.
(15 mm socket)
Flip seats forward and remove
remaining seat nuts and bolts.
(15 mm socket) Save Hardware
Remove seats.
Use OEM nuts and bolts to attach
forward K9 kit floor bracket to seat
mount locations.
Note:
If vehicle includes the Optional
OEM wire conduit, the conduit will
need to be cut or removed.
Use OEM nuts to attach rear / lower
K9 kit bracket to rear seat mount
locations.
Note:
Run wiring for Dome light,
rear fan and other equipment
prior to installing floor.
Attach rear upper floor mount
bracket to lower bracket with four
(4) 1/4”x 3/4" hex head bolts and
lock washers. (7/16 socket)
Tighten all floor bracket hardware.
Loosely attach floor to floor
brackets with eight (8) 1/4" x 3/4"
carriage bolts and serrated flange
nuts.
