KK-K9-F18-K_INST_2-13.docx
Loosely attach ceiling to rear
bulkhead with 1/4 x 3/4 round head
Phillips bolts and flat washers.
Place ceiling on top of front and
rear bulkheads.
Front and rear bulkheads in place.
Loosely attach rear bulkhead to
floor with 1/4 x 3/4 round head
Phillips bolts and flat washers.
Note:
Rear cross support brace
goes to rear of vehicle.
Loosely attach front bulkhead to
floor with 1/4 x 3/4 carriage bolts
and serrated flange nuts.
Note: Old version had round head
Phillips bolts.
Loosely attach front bulkhead to “B”
pillar brackets with 1/4 x 3/4 carriage
bolts and serrated flange nuts.
Bracket goes on inside of bulkhead
flange.
View of rear bulkhead with
reinforcement bracket.
Temporarily remove and save
lower outside 1/4 x 3/4 carriage
bolts and serrated nuts.
Attach lower front bulkhead
(
double bend
) bracket to “B” pillar
with OEM grab handle screw.
(“L” flange faces in as shown)
Remove OEM plastic side hanger
brackets.
(T-20 Torx)
