KK-K9-F18-K_INST_2-13.docx
View of passenger side lower filler
panel installed.
The previously removed rear
hard foam block will need to be
cut before reinstallation.
Mark and cut 3” inches off
forward end of foam block.
Cutting foam is very easy with an
electric steak knife.
Cut with other tool as desired.
Loosely attach upper filler panel to
rear bulkhead with 1/4 x 3/4
carriage bolt and serrated nut.
Note:
It may be easier to attach this
bolt prior to the two ceiling bolts.
Loosely attach upper filler panel to
ceiling 1/4 x 3/4 round head Phillips
bolts and flat washers.
Loosely attach ceiling to front
bulkhead with 1/4 x 3/4 round head
Phillips bolts and flat washers.
View of small upper filler panel.
Attach small upper filler panel to
large upper filler panel with 1/4 x 3/4
round head Phillips bolts and flat
washers.
Attach lower filler panel to floor
with 1/4 x 3/4 round head Phillips
bolts and flat washers.
Attach to rear bulkhead with 1/4 x
3/4 carriage bolts and serrated nuts.