English
13
OPERATION
Connect to the power source (220~240 V, 50 Hz) with the power cord and plug.
REMOTE FUNCTION OPERATION
1. OFF-TIMER
You can set the timer off for 1 Hr, 2Hrs,4Hrs and 8 Hrs. The fan will be
automatic off while the setting time out, the led indicates the hours while you
set the “OFF-TIMER”.
2. SPEED
Set the fan speed for low, middle and high speed by pressing the “SPEED”
button, the led of speed will be on and indicate speed level. The fan will be
switched on by pressing the “SPEED” button first at “MIDDLE”, then the fan
return to “LOW” three seconds later.
3. OFF
Turn off the fan by pressing the “OFF” button.
4. COMPUTER PROGRAM SYSTEM
Enjoy our computer program system by pressing the “MODE” button and
select the functions. Press one time the led will be on and in RED
colour, press again green colour, once again, orange colour. The functions
descriptions as following.
A. While the LED is in red colour, it is in nature wind mode. There are three
levels-strong, middle and low nature wind mode. It cycles from low to middle,
middle to high then, high to low. When you press the button on remote
control, the wind is on M level and normal mode, if you press “model” button
to entered the nature wind mode, the wind level is on M, and when leave the
nature wind model and enter the normal mode, the wind level will be on “M”
too.
B
.
While the LED is in green colour, it is in sleep wind mode. The wind speed
steps down automatically one level every 30 minutes and goes down to low
wind level, otherwise it switches off when “OFF-TIMER” time out.
C. While the LED is in orange colour, it is in natur sleep wind mode.
In nature sleep wind wind mode, it outputs low, middle or high nature wind,
only when the timer is off, it will switched off automatic.
5. All the functions listed above can be controlled from 10 meters at least.
If the remote control is mislaid then the functions may be controlled by pushing
the receiver buttons directly.
6. Push the oscillating knob, the fan should oscillate by about 90 degree after
operating,pull the oscillating knob to stop oscillating,the fan is pointed to one
direction only. The air flow can be adjusted upward or down by simply moving
