AXIS4000
W
HEEL
A
LIGNMENT
S
YSTEM
HAWEKA Wheel Alignment –AXIS4000
49
Trailers
13.4 Examining the trailer coupling ring in relation to the vehicle centre-line
•
Fit the camera measurement heads on the left and
right of the rear vehicle axle.
•
The magnetic feet remain on the vehicle chassis
and the reflectors are turned by 180 degrees and
attached again.
•
Place the cameras onto the wheel alignment
clamps on each side of the vehicle and align
against the reflectors on the magnetic feet.
(Fig. 102)
•
Once the reflectors have been detected, confirm
the process with the
OK button
on the camera.
•
The program then changes screen automatically.
Now the reflector stand must be secured to the
trailer coupling ring using the adapter.
•
Remove the magnetic feet from the chassis.
13.4.1 Attaching the reflector stand to the trailer coupling ring
•
Put together the reflector stand using the king pin
adapter as described for the articulated trailer under
Point 12.2.
(Fig. 103)
•
The coupling adapter is unscrewed
(Fig. 104)
and
pulled up from below into the trailer coupling of the
drawbar.
•
Now push the knurled screw with fitting plate from
above through the trailer coupling and screw the
coupling adapter securely to the drawbar.
(Fig. 105)
•
Now the king pin adapter with reflector stand is
pushed onto the coupling adapter and screwed tight
using the knurled screw.
(Fig. 106)
•
The reflectors are attached to the reflector stand
on the right and left sides.
(Fig. 102)
(Fig. 103)
(Fig. 104)
(Fig. 106)
(Fig. 105)
Summary of Contents for 924 000 010
Page 2: ......
