PTO
™
MOD
3
Owner’s Manual
AM-HPTOM3-OM
Rev AB February 2020
6
Hertz
This is the frequency in cycles per second of the AC input voltage this charger is designed to operate
on. Do not operate charger at a different frequency or from a generator with unstable frequency.
Phase
Number "1" indicates a Single Phase Charger and number “3” indicates a Three Phase Charger.
AC Volts
This is the input voltage accommodated by this charger.
Failure to use the correct voltage will result in damage to the charger and/or the battery.
IMPORTANT: THE CHARGER WILL OPERATE ONLY ON NOMINAL AC LINE VOLTAGES
INDICATED ON THE NAMEPLATE.
Config AC Amps
This is the AC current that this charger will draw with the number of power modules shown in
Config Modules on the nameplate.
Max AC Amps
This is the Maximum AC current this charger will draw from AC power. This charger must be
connected to a branch circuit protection in accordance with the National Electrical Code NFPA70
and local codes. (AC breaker/fuse values can be found on a decal outside the charger.)
Max DC Amps
This is the maximum DC current that this charger cabinet will deliver to a discharged battery when
fully populated with power modules.
DC Volts
This is the rated DC output voltage of the charger.
Config DC Amps
This is the DC current that this charger will deliver to a discharged battery with the originally-furnished
(Config Modules) number of power modules.
CEC
This logo is applied to chargers that are certified with the California Energy Commission in
compliance with Appliance Efficiency Regulations:
cULus
This logo is applied to chargers that have been tested to applicable standards and requirements by
Underwriters Laboratories (UL) and the Canadian Standards Association (CSA):
