- 4 -
INITI AL SETUP
I
MPORTANT
:
If you are going to be using the Fish Finder in Temperatures Below
20º F
(-7 ºC)
you must use Lithium ‘AAA’ Batteries. Cold
temperatures significantly reduce the power output of Alkaline
batteries, which will inhibit the performance of the Fish Finder.
I
MPORTANT
:
To ensure your FISHTRAX™ 1X remains water tight, coat the
battery cover seal with petroleum jelly
(Vaseline®)
or silicon grease
(available at any dive shop)
each time you replace the batteries
.
W
ARNING
:
Never mix different brands of batteries. Never mix new and used
batteries
(alkaline, lithium, argon zinc, & rechargeable).
Never use
damaged batteries. REMOVE BATTERIES DURING STORAGE.
REMOVE DEAD BATTERIES IMMEDIATELY.
Installing the Batteries:
1. Using a flat head screw driver, turn the screws on the
battery cover counter clockwise to loosen.
2. Lift the battery door off the display housing.
3. Install 4 “AAA” batteries. Be certain to align the batteries
as per the diagram within the battery compartment.
4. Reinstall the battery cover completely by reversing these
steps.
Connecting the Sonar Sensor Cable:
1. Align the pins on the sonar sensor cable plug with the plug on the
display.
2. Firmlly press the two plugs together until the red o-ring on the
display connector is squashed between the plugs.
3. Tighten the locking nut on the display plug until it is snug by
turning it clockwise. Finger tighten only, do not use tools.
