20
Auto Rate Detection:
This allows the Broadband Booster to
automatically detect your networks upstream data rate and speed.
It is recommended that you use the Auto Rate Detection feature
unless you are an advanced user or if you feel that your detected
data rate is incorrect.
Upstream Data Rate:
If the Auto Rate Detection feature is not
used, then the Upstream Data Rate must be manually entered.
The units used are kbits/s. Please check with your local ISP for
the correct number to be used here.
Connection Type :
Allows for manual or automatic selection of
your broadband connection type. It is recommended that this
feature be left on “Auto-detect” unless you are an advanced user
or the detected connection type is incorrect. If you have a
connection other than Cable modem or DSL please select Cable
Modem as your connection type.
Enable IP Static Mode :
For broadband connections that use
fixed IP assignments for home/work networks you may have to
manually enter the IP address for you router’s WAN port. If you
are uncertain whether your network uses IP Static settings please
check with your internet service provider or your network
administrator.
ISP Router IP Address:
If you have enabled IP Static Mode,
you may enter in the IP address of your ISP Router here.
Summary of Contents for HBB1
