15
Loosen fuel cap slowly. Rest the cap on a clean surface.
Carefully pour the fuel into the tank. Avoid spillage. Prior to
fastening the fuel cap, clean and inspect the seal located
inside the fuel cap.
Immediately replace the fuel cap and hand tighten. Wipe up
any fuel spillage.
NOTE:
It is normal for smoke to be emitted from a new engine
after first use.
STEP 4 - FILLING THE LUBRICATION OIL
Whenever you refill the fuel tank with petrol, you must also
top up the level of chain oil in the chain oil reservoir. Use
special chainsaw oil to lubricate the saw chain.
WARNING!
Lack of chain oil will seriously damage
the chain.
NOTE:
Most stores will sell acceptable oil under the name
‘chainsaw chain oil’.
IMPORTANT!
The fuel mix is added into the fuel tank (C),
chain lubrication oil is filled into the oil reservoir (D). Seal one
cap prior to removing the second cap. If you put the fluid into
the wrong tank, you must seek assistance from an expert
immediately.
OPERATING
STEP 1 - START THE ENGINE
WARNING!
Do not start the engine whilst holding the chainsaw
in one hand. There is a risk that the chainsaw may
touch your body. This is very dangerous.
1. Set the switch to the ‘1’ position.
Petrol
(Green)
Chainsaw
oil (orange)
switch
START
1
