Español
English
Fr
anç
ais
- 9 -
OPERATING INSTRUCTIONS (Continued)
ATTENTION:
When using a “ready-to-use” product in this device it may be poured directly
into the reservoir. Always refer to liquid product labels to ensure it is a “ready-to-use”
product.
5. Replace the filler cap by rotating the cap clockwise before operating the device.
Misting / Applying Liquid Product
NOTE:
Ensure device is charged prior to use. The device is designed to empty 32 fl oz of
water-based product in 6 to 7 minutes. Follow liquid product label directions and apply the
appropriate amount of liquid product based on the intended application area.
1. Position yourself in a well-ventilated area near where you would like to apply
liquid product.
2. When used outdoors, always keep the breeze at your back.
3. Slide the safety lock to the “UNLOCK” position.
4. Point the nozzle of the device toward the area where the liquid product is to be applied.
5. Slide the power switch to the “ON” position. There will be a temporary delay (up to 5
seconds) as the liquid is being fed through the device.
6. For best results, stay approximately four to eight feet from the targeted spray area.
Although the device can spray particles much further than the mentioned distances, this
increases the risk of drift and contacting non-target areas. It is also recommended to keep
the device level when spraying.
7. Always
operate your device in an upright position.
Never turn the unit upside down,
except when emptying the tank.
8. When the tank is empty or spraying is complete, move the power switch to the “OFF”
position. If the device runs out of battery while in use, always move the power switch to
the “OFF” position.
9. Slide the safety lock to the “LOCK” position so the device cannot be accidentally powered.
Safety Switch LOCK Position
LOCK
Safety Switch UNLOCK Position
UNLOCK
NOTE:
Pointing the device up at an angle can cause the liquid product to not reach the pump
and can cause the device to stop spraying temporarily, especially when the tank is less than
one quarter full. For spraying tall items (such as tree foliage) it is recommended to keep the
tank over half-full with liquid product.
