© 2002, Hayton Systems
Page 25
9.
Transactions
9.1
Retirement (X)
Use this transaction to physically retire/remove equipment from service or
from the office. Only the BSN field is required.
9.2
Transfer (T)
Use this transaction when moving cards from one plant code to another.
This transaction is used by C-to-C work order activity at the receiving end
only. No scanning is required at the sending office. Do not use this
transaction in place of an Add or Move transaction.
9.3
Swap-In (I), Swap-Out (O)
Use these transactions for non 1-to-1 card change-outs that do not
accompany a work order (example, 3 cards for 1 card). Use Swap-In and
Swap-Out transactions in conjunction with each other. Contact COEP Help
desk for further assistance.
9.4
Move (M)
Use this transaction when moving equipment between locations within the
same plant code, between different sub-plants with the same plant code, or
from an ICP cabinet to a working bay. This transaction is used mainly for
cards received from supply with the pink labels affixed to the boxes and any
equipment moved within the office.
9.5
Gross Add (G)
Use this transaction to place new equipment (or considered to be new) in an
office, or to scan equipment that was not bar coded (use region blanket
work order when entering non-labeled equipment). Do not use blanket
order for plug-in cards. Contact the local Help desk for the region specific
blanket work orders.
9.6
Change BSN (C)
Use this transaction for 1-for-1 equipment change-outs. Do not use this
transaction in place of an Add, Move, or Repair transaction.
