USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
3
Wiring
The Pro Logic or Aqua Logic main unit can connect up to a maximum of 3 remote displays. Use four
conductor cable (typically phone cable) to connect the remote display keypad with the Pro Logic/
Aqua Logic Control Center as shown below. The maximum wiring distance is 500 ft (160m). Note
that the terminals on both the Pro Logic/Aqua Logic main unit and the remote display are numbered:
Connect 1 to 1, 2 to 2, etc.
If multiple remote displays are installed: Never connect more than 2 wires to any terminal block. Two
remotes can be wired back to the Pro Logic/Aqua Logic main unit or the second remote display (and
third, if applicable) can be “daisy chained” with one remote display wired to the next. The maximum
wire run from the Pro Logic/Aqua Logic main unit to the furthest remote display is 500 ft (160m).
Wired Remote
Display unit
Aqua Logic Control Center
500 ft max
1
2
3
4
Connect screw terminals
“1” to “1”, “2” to “2”, etc.
1
2
3
4
Wired Remote
Display unit
Pro Logic Control Center
500 ft max
1
2
3
4
Connect screw terminals
“1” to “1”, “2” to “2”, etc.
1
2
3
4
