USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
12
Operation
Controls
The main controls and indicators are shown below.
Illuminates when Cell has reached the end of its expected life.
When this LED indicator is illuminated, there is a problem with
the unit. Refer to the Troubleshooting section of this manual.
Illuminates when unit is waiting for the filter pump to turn on or
is in-between generating cycles as part of normal operation to
maintain selected
.
DAILY CHLORINE OUTPUT
Illuminates when unit is actively generating chlorine.
Illuminates when unit is SUPER CHLORINATING.
Illuminates when there is no flow or low flow through the
Cell. The pool filter pump could be in its “off” cycle. If this
is not the case, refer to the Troubleshooting section in
this manual.
Blinks when performing the Flow Switch Calibration
procedure.
When you have an abnormally high bather load, a large
amount of rain, a cloudy water condition, or any other
condition which requires a large amount of purification to
be introduced, press the
button.
This electronically “super chlorinates” (boosts chlorine
generation output) the water for 24 hours (filter pump must
be on during this time). To cancel
, pres
button again.
SUPER CHLORINATING
super chlorinating
s
the SUPER CHLORINATING
Press ( + ) and ( - ) to increase or decrease the chlorine
generation. The DAILY CHLORINE OUTPUT LEDs
above these buttons will indicate the relative amount of
chlorine being generated.
