Operation
BPCUS11120 Lamp modes
The Hayward BPCUS11120 lamp is designed to operate in one of two modes; Universal ColorLogic
or Omni Direct.
Universal ColorLogic mode (default):
The lamp is shipped in this mode. Use this mode for new
installations and for installations with other Universal ColorLogic lights.
Omni Direct mode:
Omni Direct mode offers unique colors as well as speed and brightness control.
It must be configured and controlled by a Hayward OmniLogic or OmniHub pool controller only. Refer
to the controller’s manual for more information.
How to change modes:
1. Turn on lights and then turn off for between 11-15 seconds.
2. Turn on lights and then turn
off for between 11-15 seconds.
3. Turn on lights and then turn off for between 11-15 seconds.
4. The light should blink one of two colors indicating which mode it is currently in. Refer to the table
below to determine which mode the BPCUS11120 lamp is in. Note that new lights are shipped
from the factory in Universal ColorLogic mode (blinking red).
MODE
COLOR
Universal ColorLogic
Red
Omni Direct
Purple
5. To change modes, turn the light off and then back on. Continue this method until you arrive at
the desired mode. Note that Universal ColorLogic modes (blinking red) are repeated 4 times so
it may take a few cycles to arrive at Omni Direct mode (blinking purple).
6. When the light is in the desired mode, remove power from the lights for at least one minute.
7. The light will restart in the new mode the next time it is turned on.
Operating the BPCUS11120 lamp
The BPCUS11120 lamp is controlled through power-cycling: a method of changing light programs
which requires no special controller or interface. To activate the light, simply turn on the switch. To
deactivate the light, turn off the switch. To advance to the next light program (fixed color or color
show), turn the switch off, then back on within 10 seconds.
When the light has been off for over 60 seconds, and is first turned on, it will come on to white for 15
seconds for quick clear view of your pool, then go to the last fixed color or color show it was running.
Light Synchronization
If your pool or spa has multiple BPCUS11120 lamps, they may be operated independently, or they
can be easily synchronized so they will all display the same colors and shows at the same time. For
5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS