17
3
Design and Function
• For tool cleaning or cleaning of its compon-
ents we recommend using white spirit.
• Never clean with solvents or acids, esters
(organic compounds comprising acids
and alcohol), acetone (ketone), chlorinated
hydrocarbons or oils containing nitro hydro-
carbons. Do not use any chemicals with a
low burning point.
• For customer service, please contact your
HAZET distributor.
6. Malfunctions
If malfunctions occur, check the following:
• Compression system and compressed air
supply lines,
air consumption l/min and hose
cross section according to the technical
data of the tool
• Check the compressed air for the occurrence
of dust, condensate and rust particles
• Excess lubrication of the air motor
5. Maintenance and Cleaning
Lubrication:
• Pneumatic tools have to be lubricated
throughout their entire service life. The motor
and the ball bearings require compressed
air to operate the tool. As moisture from
the compressed air corrodes the motor, the
motor must be lubricated every day. We
recommend an integrated lubricator is used
to do this.
• HAZET 9070N-1 Lubricator for mounting to
the pneumatic tool.
•
Lubricating the pneumatic motor by hand:
Disconnect tool from the air supply and hold
with the air inlet pointing upwards. Put 1 or
2 drops of special pneumatic tool oil into
the air inlet.
• Connect the tool to the compressed air
supply; cover the air outlet on the tool with a
towel and operate for a few seconds.
• Never use combustible or easily evaporable
liquids such as kerosene, diesel or petrol to
lubricate the tool.
ATTENTION!
Excess oil in the motor will be imme-
diately expelled through the air outlet.
WARNING!
Never point the opening of the outlet
at any person or object. The air outlet
is located behind the handle.
Maintenance
• Always disconnect the tool from the com-
pressed air supply prior to carrying out
maintenance work.
• If used daily, carry out maintenance every
3 months, or every 1000 operating hours at
the latest.
• Damaged or worn components such as
O-rings and bearings etc. must be replaced
and all moving parts must be lubricated.
• Only use spare parts recommended by the
manufacturer, as any other parts will invali-
date any express or implied warranty.
• Ensure that the relevant environmental pro-
tection directives are observed when dispo-
sing of components, lubricants and oils, etc.
Wear hearing protection!
Summary of Contents for 9033M-11
Page 27: ...27 Notizen Notes ...