17
Always wear personal protective clothing and safety equipment!
3. Operation
• Turn on the compressor to start the filling of
the air tank.
• Adjust the air compressor regulator to 90
PSI (6.3 bar). The maximum working
pressure of this tool is 90 PSI (6.3 bar).
• The rotation performance may vary depen-
ding on the size of the air compressor and
on the output volume of compressed air.
• Do not use damaged, worn-out or low-
quality air hoses or connectors.
• Do not use sockets or accessories intended
for manual use.
• Make sure to use only impact sockets of the
appropriate size.
• Push throttle lever to operate the tool.
• Turn regulator to adjust the power and
sense of rotation. Forward operation = F;
reverse operation = R.
• The tool includes 3 power settings in for-
ward and 1 power setting in reverse opera-
tion.
• Release throttle lever to stop tool operation.
• Be aware of the fact that the tool continues
moving for a while after the throttle lever has
been released.
• When the work is done, switch off com-
pressor and store it as indicated in its
operating instructions.
• Use clean and dry air at 90 PSI (6.3 bar)
maximum pressure only. Dust, combustible
steams and a too high moisture can
damage the motor of a pneumatic tool.
• Do not remove any stickers; replace
damaged stickers.
• Keep hands, wide clothing and long hair
away from the moving parts of the tool.
2. Prior to Operation
Pneumatic tools have to be used,
inspected and maintained always
in compliance with the respective
local, state, national or federal
regulations.
• Drain compressor tank and remove conden-
sation water from the air hoses. Read thou-
roughly through the operating instructions of
the compressor tank too.
IMPORTANT:
The use of an air filter and an air hose
oiler is recommended.
ATTENTION!
Before oiling, plugging in/out the
tool, disconnect the tool from the
compressed air supply.
• For oiling the tool, see chapter 4
“Maintenance and Cleaning”
further on in
these operating instructions.
• Remove the dust cap at the air inlet.
• Connect the tool to a correctly sized air
hose.
See table on page 16
햴
Design and Function
GB
USA
Summary of Contents for 9012 SPC
Page 19: ...19 Notizen Notes ...
