15
HAZET-WERK
Hermann Zerver GmbH & Co. KG
;
Güldenwerther Bahnhofstraße 25 - 29 • 42857 Remscheid • GERMANY
[
+49 (0) 21 91 / 7 92-0 •
\
+49 (0) 21 91 / 7 92-375 •
^
hazet.de •
]
info@hazet.de
•
Do not use the tool in rooms with an
explosive atmosphere.
Tools such as san-
ders can cause sparks that may ignite com-
bustible materials. Never operate tools in
proximity to combustible substances like
petrol, naphtha or detergents etc. Work in
well-cleaned and well-ventilated areas only.
Keep combustible materials out of the work
area. Never use oxygen, carbon dioxide or
other bottled gases to power pneumatic
tools.
•
Do not point the tool at another person.
Keep children and other persons out of the
work area when operating the tool.
•
Do not operate the tool in an idle state.
•
Do not allow pneumatic tools to come
into contact with sources of electricity.
•
Pay attention to the working pressure.
For
max. air pressure see table on page 16.
Exceeding the approved maximum pressure
of tools and accessories may cause explo-
sions and may result in severe injuries. The
maximum pressure of the compressed air
must be equal to or less than the approved
pressure load indicated for the sander.
•
Check the air hose connections are fit-
ted tightly. Do not use defective pressu-
re hoses.
Uncontrollably moving pressure
hoses may cause severe injuries.
•
Only disconnect pneumatic tools in an
unpressurised state.
Uncontrollably moving
pressure hoses may cause severe injuries.
•
Only use clean and dry air.
Never use oxy-
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
•
Only use spare parts, attachments and
accessories recommended by the manuf-
acturer.
•
Never carry the tool by the compressed
air hose.
•
Never carry the connected tool with a
finger on the operating lever.
•
Avoid unintentional activation.
•
Always keep the handles dry, clean and
free of grease or oil.
•
Ensure that the working area is clean,
well ventilated and always well lit.
•
Never use the tool whilst under the influ-
ence of alcohol or drugs.
•
Repair work must be carried out exclusi-
vely by authorised persons.
•
Labels on the tool must always be kept
legible. The user is responsible for ensu-
ring that the sticker stating warning signs,
rotation speed, the serial no. and the
article no. is not damaged and is easy to
read.
•
Do not use quick-release couplings
directly on the tool. There must be a
pressure hose of at least 20 cm in length
between the tool and the quick-release
coupling.
•
Only replace abrasive belts when
the air hose is disconnected.
Always disconnect the tool
from the compressed air supp-
ly before lubricating or replacing the
abrasive belts.
2
For your safety
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!
Summary of Contents for 9033 N-4
Page 21: ...21 21 Notizen Notes ...
Page 22: ...22 22 Notizen Notes ...
Page 23: ...23 23 Notizen Notes ...
