18
^
hazet.com •
]
info@hazet.de
• Never clean with solvents or acids, esters
(organic compounds comprising acids
and alcohol), acetone (ketone), chlorinated
hydrocarbons or oils containing nitro hydro-
carbons. Do not use any chemicals with a
low burning point.
• For customer service, please contact your
HAZET distributor.
6. Malfunctions
If malfunctions occur, check the following:
• Compression system and compressed air
supply line,
air consumption l/min and hose
diameter according to the technical data of
the tool
• Check the compressed air for the occurrence
of dust, condensate and rust particles
• Excess lubrication of the air motor
5. Maintenance and Cleaning
•
Lubrication:
Pneumatic tools have to be lubrica-
ted throughout their entire service life.
The motor and the ball bearings require
compressed air to operate the tool. Since
the moisture in the compressed air corrodes
the motor, the motor must be lubricated
every day. We recommend that an integra-
ted lubricator is used to do this.
• HAZET 9070N-1 lubricator for mounting to
the pneumatic tool.
•
Lubricating the pneumatic motor by
hand:
Disconnect tool from the air supply and
hold with the air inlet pointing upwards. Put
1 or 2 drops of special pneumatic oil into
the air inlet.
Connect the tool to the compressed air
supply; cover the air outlet on the tool with
a towel and operate for a few seconds.
Never use combustible or easily evaporable
liquids such as kerosene, diesel or petrol to
lubricate the tool.
ATTENTION!
Excess oil in the motor will be imme-
diately expelled through the air outlet.
WARNING!
Never point the opening of the outlet
at any person or object. The air outlet
is located at the back of the handle.
•
Maintenance
Always disconnect the device from the
compressed air supply prior to carrying out
maintenance work.
• If used daily, carry out maintenance every
3 months, or every 1000 operating hours at
the latest.
• Damaged or worn components such as
o-rings and bearings etc. must be replaced
and all moving parts must be lubricated.
• Only use spare parts recommended by the
manufacturer, as any other parts will invali-
date any express or implied warranty.
• Ensure that the relevant environmental pro-
tection regulations are observed when dis-
posing of the components, lubricants and
oils, etc.
• For tool cleaning or cleaning of its compon-
ents we recommend using white spirit.
3
Design and function
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!
Summary of Contents for 9033 N-4
Page 21: ...21 21 Notizen Notes ...
Page 22: ...22 22 Notizen Notes ...
Page 23: ...23 23 Notizen Notes ...
