17
HAZET-WERK
Hermann Zerver GmbH & Co. KG
;
Güldenwerther Bahnhofstraße 25 - 29 • 42857 Remscheid • GERMANY
[
+49 (0) 21 91 / 7 92-0 •
\
+49 (0) 21 91 / 7 92-375 •
^
hazet.de •
]
info@hazet.de
3
Design and Function
Troubleshooting / Avoidance:
• Never pull the plug from the socket using
the cable.
• Always pull the plug to avoid damaging the
cable.
• Firmly hold the charger with your hand and
remove the battery from the charger.
• The battery and the charger heat up slightly
when recharging. This does not reduce
their functionality. Appropriate caution is
required for operation.
• After charging, take the required 15 minutes
of wait time before charging again.
• If the charger detects an overheated bat-
tery, all 3 charging LEDs flash at the same
time. Remove the battery and let the char-
ger cool for about 15 - 30 minutes before
you continue charging.
• If the charger detects a malfunctioning
battery, 2 charging LEDs flash at the same
time. Please remove the battery and allow it
cool for about 15 - 30 minutes. Should both
charging LEDs continue to flash afterwards,
the battery may be defective. Please send
us the battery immediately for analysis.
• If the charger has a defect, all 3 charging
LEDs flash at the same time. Please remove
the battery and disconnect the charger from
the mains. After 2 minutes, insert the plug
into the socket outlet again and insert the
battery. Should all 3 charging LED's still be
flashing, send the charger immediately to us
for analysis.
Electric energy may cause serious injuries!
Always wear personal protective equipment!
